![]() And that range will change depending on the material I am engraving. So I would like to engrave images between 70-90% or just keep testing and fine tuning the range once I figure out the optimal settings. I haven’t tested it yet but I’m guessing it’s around 50-70% where it just doesn’t really do much to the wood. The reason for this is because my laser will barely mark balsa wood below a certain power level. So far, LaserWeb is the best tool I have found and it allows me to change the power limits to, for example, 70 - 90%. But since I have such little power on my cheap 2.5W laser, I wanted something that will allow me to change the power output and ranges of powers for a certain image. ![]() I have had success with JTech Photonics tool as well as the raster2gcode tool. ![]()
0 Comments
Leave a Reply. |